Replacing Bathroom Vanity And Sink

Changing out your bathroom vanity as well as sink can be a fantastic method to upgrade the appearance of your restroom without investing a great deal of cash. It's a project that a lot of do-it-yourselfers can handle with a little preparation and the best tools.

Prior to you start, it's vital to measure your existing vanity and also sink to make certain you get a replacement that will certainly fit. You'll additionally require to shut off the water supply to your bathroom and remove the old vanity as well as sink. When you've done that, you can install the brand-new vanity and sink adhering to the manufacturer's guidelines.

Equipment you'll need

Screwdriver
Wrench
Adjustable wrench
Putty knife
Level
Caulk gun
Tape measure
Pencil
Safety glasses
Dust mask

Steps involved

Before beginning, secure the water supply to your bathroom by shutting off the valves under the sink. Once the water is off, open the taps to drain any remaining water from the lines.
Disconnect the supply lines from the faucets. Utilize a wrench to loosen the nuts that hold the lines in place. Be careful not to overtighten the nuts, as this can damage the lines.
Disconnect the drain line from the sink. The drain line is the pipe that connects the sink to the drain in the wall. To detach the drain line, loosen the nuts that hold it in place. Be careful not to drop the nuts down the drain.
Remove the old vanity and sink. Once the vanity and sink are disconnected from the plumbing, you can remove them from the bathroom. Be careful not to damage the walls or floor when removing the vanity and sink.
Install the brand-new vanity. Position the brand-new vanity in the bathroom and level it utilizing a level. Once the vanity is level, secure it to the wall using screws.
Install the new sink. Place the brand-new sink on the vanity and align it with the faucet holes. Once the sink is aligned, secure it to the vanity utilizing screws.
Reconnect the supply lines to the faucets. Use a wrench to tighten the nuts that hold the lines in place. Be careful not to overtighten the nuts, as this can damage the lines.
Reconnect the drain line to the sink. Connect the drain line to the sink and tighten the nuts that hold it in place. Be careful not to overtighten the nuts, as this can damage the drain line.
Turn on the water supply to your bathroom and check for leaks. Once the water supply is on, open the taps and check for leaks. If you see any leaks, tighten the nuts that hold the supply lines and drain line in place until the leaks stop.