How To Install A Vanity Light

Installing a vanity light is a relatively simple task that can be completed in a few hours.

Before you begin, you will need to gather the following materials:

A vanity light
Screwdriver
Drill
Wire cutters
Electrical tape
Level

Once you have gathered your materials, you can begin the installation process.

To start, you need to turn off the power to the circuit that will be powering the vanity light. You can do this by flipping the breaker or removing the fuse.
Next, you need to remove the old vanity light. To do this, simply unscrew the screws that are holding it in place and pull it straight down.
Once the old vanity light is removed, you can install the new one. Start by screwing the mounting bracket into the wall. Make sure that the bracket is level by using a level. Once the bracket is secure, you can attach the vanity light to the bracket.
Once the vanity light is attached, you need to wire it. To do this, simply connect the black wire from the vanity light to the black wire from the circuit. Connect the white wire from the vanity light to the white wire from the circuit. And connect the green or bare wire from the vanity light to the ground wire from the circuit.
Once the vanity light is wired, you can turn the power back on. To do this, simply flip the breaker or insert the fuse.
Finally, you can test the vanity light to make sure that it is working properly. To do this, simply turn on the light switch. If the vanity light turns on, then you have successfully installed it.

Installing a vanity light is a simple task that can be completed in a few hours. By following these steps, you can easily install a vanity light in your bathroom or powder room.