How To Install A Vanity Sink

Installing a vanity sink is a relatively simple plumbing project that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber and have a new sink installed in no time.

Step 1: Gather Your Materials

Before you begin, you will need to gather the following materials:

Vanity sink
Faucet
Drain assembly
Pliers
Wrench
Screwdriver
Putty knife
Caulk gun
Caulk

Step 2: Remove the Old Sink

If you are replacing an existing sink, you will need to first remove it. To do this, turn off the water supply to the sink and disconnect the water lines. Then, use a putty knife to loosen the caulk around the sink. Once the caulk is loose, you can unscrew the mounting nuts and remove the sink.

Step 3: Install the New Sink

To install the new sink, first place it in the vanity and mark the location of the mounting holes. Then, drill pilot holes for the mounting screws. Apply a bead of caulk around the base of the sink and then set the sink in place. Secure the sink with the mounting screws.

Step 4: Install the Faucet

To install the faucet, first insert the mounting gaskets into the holes in the sink. Then, thread the faucet body onto the mounting studs and tighten the nuts. Connect the water lines to the faucet and turn on the water supply.

Step 5: Install the Drain Assembly

To install the drain assembly, first insert the rubber washer into the drain hole. Then, thread the drain body onto the drain hole and tighten the nut. Connect the drain pipe to the drain body and tighten the nut.

Step 6: Caulk the Sink

To caulk the sink, first apply a bead of caulk around the base of the sink. Then, use your finger to smooth out the caulk. Allow the caulk to dry completely before using the sink.